img

Cleaning & Maintenance

Cleaning Cloth Care Instructions

  • Washing under 40°C (104°F).
  • Do not bleach.
  • Do not use softener.
  • Do not tumble-dry.
  • Do not iron.
  • Do not dry clean.

Care Frequency: After each use.

img

Please contact a local retailer or local authorized dealer for additional consumable spare parts.

Replace the water tank

  1. Use a Philips screwdriver to uncrew the water tank.
  2. Disconnest the cable from the old water tank and then slide out the water tank.
  3. Connect the new water tank to HOBOT and slide the tank back, then fasten the screw.

Care Frequency: When ultrasonic nozzle is clogged and cannot spray water.
Please contact a local retailer or local authorized dealer for additional consumable spare parts.

img

Replace the ultrasonic spray nozzle

&#9199 Watch video demonstration: https://youtu.be/zlthawGVoks

  1. Follow above istructions to disattach the water tank.
  2. Lift the rear side of the plastic cover around the spraying nozzle lightly, and apart the plastic cover from the water tank.
  3. Lightly lift up the silicone ring and apart it from the water tank. Don’t press the welding spot and/or ultrasonic nozzle.
  4. Place the new ultrasonic spray nozzle on the water tank, make sure the connecting cable is aligned to the lower edge of the water tank, then fit the bottom of the silicone ring to the water tank.
  5. Press the silicone ring to secure it, then use another finger push the top of silicone ring into the water tank lightly.
  6. Please check if the new ultrasonic spray nozzle fits the water tank tightly.
  7. Let the connecting cable through the hole on the plastic cover and restore the front side of plastic cover to the original position.
  8. Connect the new water tank to HOBOT and slide the tank back, then fasten the screw.

Care Frequency: When ultrasonic nozzle is clogged and cannot spray water.
Please contact a local retailer or local authorized dealer for additional consumable spare parts.

Clean two laser sensors

Use a clean and dry soft cloth to clean two sensors.
Care Frequency: Before each use.

img

Clean the caterpillar belt

To avoid slipping, please wipe the accumulated dust off the caterpillar belts.

  1. Flip HOBOT upside down.
  2. Turn on the power switch, HOBOT’s caterpillar belts will continually run for 3 minutes.
  3. Please use a cloth to clean the caterpillar belts and keep cloth at the middle of belts to avoid the cloth getting caught in the belts. In case the cloth is caught, please turn off the power and pull the cloth out.

Care Frequency: Before each use.

img